ST-PG3000 Polyurea Ceramic Tile Sealer
Introduction
Use
Parameters
|
Model |
ST-PG3000 |
|
|
Glue Strip Appearance |
Uniform and delicate, no obvious bubbles, particles |
|
|
Swell (Vertical) / Mm |
≤3 |
|
|
Drying Time /H |
Surface Dry |
≤1 |
|
|
Solid Dry |
≤5 |
|
Wear Resistance (1000g / 500 Rpm) / mg |
≤40 |
|
|
Shore Hardness (Type D) |
≥50 |
|
|
Flexibility (Membrane ss 1mm thick) / Mm |
≤3 |
|
|
Glossiness |
Customizable |
|
|
Water Resistance (168h) |
No foaming, no fall off, no obvious discoloration |
|
|
Acid And Alkali Resistance |
Alkalinity Resistance (5%NaOH, 24 H) |
No foaming, no fall off, no obvious discoloration |
|
|
Acid Resistance (5%h2SO4,24 H) |
|
|
Yellowing Resistance |
＜1 |
|
|
Pollution Resistance |
Red Wine |
≤2 |
Construction Recommendations
1. Cleaning: Clean the dust, water, oil on the surface of the product, and keep the surface dry.
2. Stir: Before the ratio, stir agent A to divide the bottom pigment (filler) into the glue.
3. Ratio: Weigh and pour in turn according to the A / B ratio of the purchased product (* Note: according to the weight ratio, non-volume ratio).
4. Mix: Mix the ratio of A / B glue, stir fully to avoid incomplete curing.
5. Defoaming: Put the mixed glue static 5-10 minutes of bubbles will automatically discharge, if possible can be vacuum defoaming.
6. Seal: Seal the defoaming adhesive material into the required adhesive product, please use it up within the operational time.